VMware vSphere 5.0 - не может настроить хост на нескольких подсетях

Получите Удаленный рабочий стол Apple, и затем можно вставить машины к "Режиму Занавесок", который в основном запрещает настольному пользователю от выполнения чего-либо.

Я знаю, что ARD не свободен, но если Вы управляете больше чем 10 или 15 Mac, он очень быстро платит за себя в способе, которым помогает, что Вы действительно меньше работаете.

0
задан 8 March 2017 в 10:00
2 ответа

You stated that you cannot communicate to the newly assigned address - where are you trying to communicate from?

For non-routed traffic (within the same subnet), your newly assigned VMkernel addresses should already be working just fine. You should be able to verify by communicating with them from another device on the new 10.13.110.0/26 network.

Routed traffic is another story. Two issues with routed traffic:

  • Something needs to handle inter-vlan routing - if it's that 3750 (I'm guessing not - I'd expect the gateway to be .1 or .63, not .62) then it's not got an address on the new 10.13.110.0/26 network.
  • Only one gateway is permitted for all VMkernel traffic - setting up the gateway on the new subnet will drop the config for the old subnet's first hop.

Since your subnets are sliced into very small chunks (what's up with that, anyway? Does someone in your organization need reminded that 10.0.0.0/8 contains 16.8 million addresses?), I bet most of these hosts' communication is routed.

The tricky step of this migration for you will be the change to the hosts' gateways, as everything that's connecting to them from outside the subnet will need to be switched over to the new address.

1
ответ дан 23 November 2019 в 11:05

Необходимо правильно различать сеть VMware Host и сеть VMware гостевую .

Как правило, это единственный сетевой трафик, который напрямую связан с хостом VMware. машины - это (Vcenter) управление и связь, связанная с кластером.

Трафик к и от отдельных гостей VMware совершенно не связан с этим; фактически, они обычно не должны быть подключены к одной и той же сети.

Тем не менее, порты виртуального коммутатора могут быть соединены транками или тегами, или что угодно для гостевых виртуальных машин.

0
ответ дан 23 November 2019 в 11:05

Теги

Похожие вопросы